Posted on

how to germinate cannabis

Gently water the soil with a spray bottle and situate your pots under a fluorescent lamp. Keep seeds away from the windowsill, as the temperature is too volatile for germination. In general, you’ll want to keep the temperature in the range of 70 to 80 degrees Fahrenheit.

The best germination method depends on the cultivator’s choice. Here are some of the most common ways to pop your cannabis seeds.

How to germinate seeds in soil

Place the soil in a small pot and use your finger or a pencil to push a small hole in the dirt, a bit more than half an inch deep. Insert the seed into the hole and bury it with soil. From this point on, don’t touch your seed. The young plant is fragile and knows how to position itself in the soil bed.

You can also germinate your seeds by placing them in water. It’s slightly faster than the soil method, but you need to adjust your environmental factors accordingly. Remember, successfully germinating seeds requires a perfect balance of ideal growing conditions. When germinating in water, seeds need only 24-48 hours to pop their stems, though cultivators can keep them soaking for up to a week as needed. Water germination is faster because the seed gets all the moisture it needs immediately, and the shell softens and cracks more easily after soaking.

When the seedling stems reach two to four inches in height, it’s time to transplant your cannabis into larger pots with more room for roots to spread down and out. After you’ve done this, you’ve successfully germinated your cannabis seeds into proper, young plants.

One drawback of clones is they need to be taken during the vegetative stage of a plant—flower is too late—so if you have a small setup with only one light, it can be hard to keep clones alive while flowering other plants, because the two need different amounts of light.

You can also minimize headaches and avoid the hassle of seed germination and sexing plants by starting with clones.

Top feminized cannabis strain families

Cannabis plant sex organs appear on nodes, the points where branches grow off from the main stalk.

Growing marijuana takes a certain level of commitment: time, energy, and financial resources, so be sure you can commit to the whole process.

Germination is the process in which a seed sprouts and begins to grow into a new plant. Also referred to as “popping,” germination is the very first step in starting your weed grow.

New seedlings should be given access to bright light from the time they emerge. Care should be exercised in the first week or two, as seedlings are still quite delicate.

Place the plates somewhere warm (21ºC) and away from direct light.

Check the seeds every day to ensure that the tissue does not dry out. Spray the tissues with water if necessary.

Step 3. Potting – How to germinate cannabis seeds

Place another few layers of moist tissue on top of the seeds, again allowing excess water to drain off.

Line the bottom of the first plate with a few layers of wet tissue and drain any excess water from the plate.

When the first few millimetres of root have emerged from a germinated seed, each one should then be carefully transferred to a small container of growing medium (soil, coco-fibre or rockwool).

Place the cannabis seed, root first, into the hole and cover with a small amount of growing medium – just enough to block light, not enough to obstruct the seedling when it emerges.