Posted on

growing skunk from seed

Seedlings require a medium amount of light in which it has enough to grow but not too much light that it gets burned. Leaving your seedling in direct sunlight will cause the leaves to curl, while too little light will cause the seedling to stretch. If growing outside, seedlings want to see a direct light source to stop them stretching. If inside, a sunny windowsill with more than half a day of sunlight works wonders. Otherwise, 18 in away from a growing light works excellently. Your seedling should not stretch more than 6 in at most. We’ll cover lighting in more depth in a later blog.

To accelerate germination, you are going to want to soak your seed in a small container with lukewarm water and place it in a dark and warm place for 12-24 hours, but no longer. By drenching the seed, it absorbs the water thoroughly, activating the germination process. Doing this also helps to loosen the shell as it becomes a little softer making it easier for the embryo to crack it open. When your seed sinks to the bottom it is ready to be planted, and sometimes the seed will pop out a small taproot. A seed can still be planted though if it does not sink.

Perhaps the most exciting stage, your baby will typically come above ground in 1-2 weeks. As your seedling comes above the soil, its shell might take a few days to fall off. It’s best to leave it alone, nature has the job covered. If it does not come above ground after about two weeks, the chance of success is dramatically reduced, and it’s best to try again. Even the best seeds have an 85% germination rate. When your seedling comes above ground, it is going to want to see a direct light source.

3) Above the ground

Raising a seedling, however, requires some patience, gentle hands, and a smidgen of luck. Thankfully pot seeds are remarkably vigorous because they are what’s called endosperm seeds, which means they have almost pre-formed cotyledon leaves before you even add water. Below is a brief guide on the techniques we have found yield the most success when starting seeds and raising your seedling to a healthy plant ready for transplanting.

Our favorite thing about starting from a seed, rather than a clone, is that you get to see the full life cycle and enjoy a plant that is unique, just like you. An entirely new genetic makeup will enter the world for the first time, and if you’re lucky, something remarkable might be born.

For young plants, it’s best to use bottled water as it has no chlorine added. If using tap water, let it sit for 24 hours before watering to dissipate any chlorine. Chlorine can also be eliminated by boiling for 20 minutes. Under normal conditions, after soaking your seedling pellet, it should contain all the moisture your plant needs before it comes above ground. As it grows, it will only need about a shot glass worth of water at most per week to keep the medium damp. Seedlings don’t drink a lot of water, which makes sense given their size. Your plant will do better in a growing medium which is damp. Overwatering is just as deadly as drying out.

We like to use seedling pellets that are made of a mix of compressed peat moss and coco husk. To expand, soak it in water for 10 minutes. Once your seedling pellet has absorbed enough water and has expanded to its maximum size, drain off any excess water. The growing medium should be like a damp sponge that would not leave streaks on the table. Dig a small hole about 1/4 in deep for your seed. Use a spoon to lift the seed out of its bath. If it has popped out a taproot be careful not to damage it. Gently place the seed into the hole and lightly cover it with dirt from the pellet. Now that you have started the germination process, your seedling will come above ground within two weeks. The older the seed, the longer it takes for it to germinate.

Learning Made Easy

Dummies has always stood for taking on complex concepts and making them easy to understand. Dummies helps everyone be more knowledgeable and confident in applying what they know. Whether it’s to pass that big test, qualify for that big promotion or even master that cooking technique; people who rely on dummies, rely on it to learn the critical skills and relevant information necessary for success.

Copyright © 2021 & Trademark by John Wiley & Sons, Inc. All rights reserved.

There’s all sorts of techniques to keep plant size under control.

With the lights off, drying net in place, and exhaust fan running at 50%, air humidity slowly drops. Your buds are dry as soon as bending branches makes them snap.

Keeping Your First Cannabis Home Grow In Check

Indeed, we’ve been saving the best for the last: harvesting those plants to find out how much they yield! It’s almost time to start trimming. At this point, keep the air humidity n your tent between 30 and 45% to prevent fungi and bud rot issues. You don’t want to lose all that hard work right before the finish line!

You’re probably thinking: grow plug? Propagator? Root stimulator? What?! No worries: germinating is 100% natural. All cannabis seeds really need is light and water. Check out my preferred germination method here, or follow this grow guide to plant germinated seeds directly into the soil. Find out what works best.

Once the seeds become seedlings, with roots showing on the sides and bottom of the grow plus (usually after about four days), they’re ready for planting. I start with small P9 size flower pots. I’ll leave them for 7 to 11 days to give the roots time to develop, creating a stable habitat.